Mix minus kit for the LPB series II / SC-13

Where the magic happens...or something...
Post Reply
spareparts
Posts: 45
Joined: Sun Feb 11, 2018 12:02 pm

Mix minus kit for the LPB series II / SC-13

Post by spareparts »

Looking for the mix-minus kit (LPB part #1150 ) for a LPB series II SC-13, or failing that, a schematic and to measure the card edge connector and trace information to see if I can make the board myself.
User avatar
Shane
Posts: 934
Joined: Fri Feb 01, 2008 12:08 am
Location: Omaha
Contact:

Re: Mix minus kit for the LPB series II / SC-13

Post by Shane »

Did you find it? If not, Henry Engineering used to have a mix minus box for older consoles which didn’t accommodate that. However, they won’t work on all consoles. I was not able to get one to work on an old McMartin, I think because of a very low impedance mix bus in the McM.
Mike Shane, CBRE
— — Omaha — —
spareparts
Posts: 45
Joined: Sun Feb 11, 2018 12:02 pm

Re: Mix minus kit for the LPB series II / SC-13

Post by spareparts »

No luck - ended up going with a different console that supported mix-minus

SP
Post Reply