Page 1 of 1

Add limiter on Mic #1 on BMX-II Console

Posted: Sat Jun 07, 2014 8:17 pm
by ChuckMizner
How do I add a limiter on Mic #1 on the BMX-II? (How do I tap into the Mic Pre Amp before it hits the board?)

Thank you all.

CMc

Re: Add limiter on Mic #1 on BMX-II Console

Posted: Mon Jun 09, 2014 9:58 am
by Bill DeFelice
Before I replaced the BMX with another console I just put an attenuator in front and fed the mic processor into that channel. I probably could have bypassed the preamp stage with without the manual handy I took the lazy way out. You could just build up an attenuator or use a Shure A15LA XLR line to mic adapter if you don't want to roll your own.

Re: Add limiter on Mic #1 on BMX-II Console

Posted: Mon Jun 09, 2014 10:32 pm
by ChuckMizner
Bill,
Thanks for the reply, Shure A15LA is spoken here.
CMc