need switch settings for 1630 kHz.
Also 1310 alignment procedure
thanks
Need Dip Switch settings on (/\/\) Motorola 1310
Need Dip Switch settings on (/\/\) Motorola 1310
kc8gpd
"The scientists of today think deeply instead of clearly. One must be sane to think clearly, but one can think deeply and be quite insane."
- Jim Sofonia
- Posts: 132
- Joined: Fri Jan 30, 2015 11:15 pm
Re: Need Dip Switch settings on (/\/\) 1310
Motorola 1310 Monitors
kc8gpd
"The scientists of today think deeply instead of clearly. One must be sane to think clearly, but one can think deeply and be quite insane."
Re: Need Dip Switch settings on (/\/\) 1310
Probably the next sequence after 1620 kHz.
Bob M.
Bob M.
Re: Need Dip Switch settings on (/\/\) 1310
Which I would think is 11010000 (208). However, the monitor may not see it as valid.
Re: Need Dip Switch settings on (/\/\) Motorola 1310
I added Motorola to your thread title, so it will be searchable.
People won't search for "(/\/\)".
People won't search for "(/\/\)".
http://www.necrat.us
"Arguing with an engineer is like mud wrestling with a pig. After a couple of hours, you realize the pig likes it"
"Arguing with an engineer is like mud wrestling with a pig. After a couple of hours, you realize the pig likes it"
Re: Need Dip Switch settings on (/\/\) Motorola 1310
i wound up grabbing one of those Radio Engineering Associates AMM-SD1 monitors. figured it was cheap enough and more accurate than messing with the old Motorola monitor and takes up less rack space 

kc8gpd
"The scientists of today think deeply instead of clearly. One must be sane to think clearly, but one can think deeply and be quite insane."