Will this STL link work?

Want to know how something works? Harness the power of the Brainiacs!
Post Reply
User avatar
abwdvm
Posts: 70
Joined: Fri Jul 17, 2015 7:32 pm
Location: Tx
Contact:

Will this STL link work?

Post by abwdvm »

Completely out of my league here.. We are moving an existing Nicom 9XX STL link.

This is a plot of the new proposed location. Anyone want to hazard a guess if it will work?
stl.jpg
technician at an 1000w AM station in Texas
User avatar
Deep Thought
Posts: 3555
Joined: Thu Mar 20, 2008 9:23 am
Location: La Grange, IL
Contact:

Re: Will this STL link work?

Post by Deep Thought »

What is in the area which penetrates the 60% zone? This path is less than 10 miles and shouldn't be terribly fussy even with some diffraction loss.

Send me the TX and RX location coordinates, the antenna elevations above sea level and the antenna types and I'll run a path profile with the proper parameters. I'm assuming this is a 950 MHz analog link.
Mark Mueller • Mueller Broadcast Design • La Grange, IL • http://www.muellerbroadcastdesign.com
User avatar
kkiddkkidd
Posts: 947
Joined: Mon Dec 03, 2007 11:13 am
Location: Lawrenceburg, TN

Re: Will this STL link work?

Post by kkiddkkidd »

I'm also assuming 950mhz STL signal...

Is the path & fresnel zone shown done at 950? It looks mighty skinny for 950mhz at 13km.

Regards,
--
Kevin C. Kidd CSRE/AMD
WD4RAT
AM Ground Systems Company
http://www.amgroundsystems.com
KK Broadcast Engineering
http://www.kkbc.com
User avatar
Deep Thought
Posts: 3555
Joined: Thu Mar 20, 2008 9:23 am
Location: La Grange, IL
Contact:

Re: Will this STL link work?

Post by Deep Thought »

That looks like it is 2.4 or 5 GHz. I ran the path study for him and at 950 it's a lot "fatter" at 60%, but only loses 4.5 dB because of it.
Mark Mueller • Mueller Broadcast Design • La Grange, IL • http://www.muellerbroadcastdesign.com
Post Reply