Processing Pre or Post STL?

FM does it with frequency!
DaveSt
Posts: 56
Joined: Mon Jul 23, 2018 2:21 pm
Location: UK

Re: Processing Pre or Post STL?

Post by DaveSt »

Nathaniel Steele wrote:
Tue Jul 24, 2018 12:52 pm
Doesn't the 2200 have a serial port for remote control? You could put an IP to serial converter at the midpoint for remote control, if you have IP access at the midpoint.
Just a GPIO port with pins you can use to select processing presets. No possibility for serial comms as I recall. Not that there is much to play with anyway. The 2200 is a lovely box though. Still my favourite processor of all time.

Post Reply